How to solve the daily problems of poultry manure dryer machine ?

In the daily operation of poultry manure dryer machine, inevitably, there will be some problems, although most are small problems, it is necessary to solve it in time, to avoid occur serious problems.


>>> Air leakage problems of poultry manure dyer machine.

Air leakage will cause heat loss and increase the heat comsumption, and reduce the drying capacity. Then how to solve the air leakage ?

*** Close the hot air furnace door after you feed the fuel;

*** Check the connection position of the related air duct, dust catcher, and repair it accordingly.

*** Check the dryer's inlet cover and outlet cover, and repair it accordingly.


>>> Poultry manure dryer can not dry the wet manure ?

*** Without preheat the dryer rightly, and then begin to feed wet manure into the dryer, and cause more and more wet manure stick to the inner wall of the dry cyclinder, then cause very low heat efficiency. Before feeding wet manure into the dryer,, preheat the poultry manure dryer and the inlet temperature should be up to about 250-300 centigrades in advance.

*** The dryer size is too small, but meantime feed too much manure into the dryer. To feed the suitable quantity of wet manure according to the designed capacity.

*** The induced fan is too small and can not suck out the water vapor out of the dryer in time. To supply the right induced fan according to the water evaporation quantity and air volume of exhaust air.

*** The burner and hot air furnace can not supply enough heat for the poultry manure drying system. To use bigger heat output burner and hot air furnace.


>>> The hot flue gas can not pass through the poultry manure dryer smoothly.

*** The air duct is blocked, find the blocked position and clean it.

*** The related matched machines is blocked, for example, if use condenser to process the exhaust air, as the condenser with many inner small size pipes, which will be blocked after long term use. Thus need to clean the related pipes in time.
 

>>> Abnormal sounds comes out from induced fan.

*** There are much dust adhered on the impeller, then needs to clean it in time.
*** The impeller is worn out, need to change new one.